Omigo & Omigo SL
1. Mounting Bolt (2)
2. Rubber Cone Washer (2)
3. Flat Washer (2)
4. Barrel Nut (2)
5. Mounting Plate
6. Adjustable Brackets (2)
7. T-Valve Connector with Rubber Washer
8. Bidet Hose
9. Cable Clips (2)
10. Remote Control Wall Mount
11. Remote Screw (2)
12. Remote Anchor (2)
13. CR2032 Batteries (4)
Omigo GS
1. Mounting Bolt (2)
2. Rubber Cone Washer (2)
3. Flat Washer (2)
4. Barrel Nut (2)
5. Mounting Plate
6. Adjustable Brackets (2)
7. T-Valve Connector with Rubber Washer
8. Bidet Hose
Alternate hardware for specialized installation
Please contact us, we are happy to provide you with alternate hardware, free of charge.
Top Mount Hardware
Used for toilet fixtures that only have top-side access to the mounting bolts that hold the seat to the toilet. Please see our Top Mount Installation article for more details!
Alternate T-valve
Used for toilet fixtures with a concealed fill valve. This T-valve connects to the water supply valve at the wall, instead of at the fill valve which is normally under the bottom of the toilet tank.
Please Note: Only use the provided installation hardware
Please contact us if you need alternate parts for your installation, we provide approved alternate hardware as needed. Substituting with unapproved or third-party parts will void your warranty, and Omigo will not be held liable for damages.
Top mount hardware installation
- Remove the screw and washer from the rubber expansion bolt.
- Insert the rubber expansion bolt into the bolt holes of the toilet.
- Place the black mounting brackets into the mounting plate and place over bolt holes on the toilet; the rubber side faces down, curved edge faces toward the toilet tank.
- Align the washer over the brackets and bolt holes, then snap into place.
- Insert the screws through the washers and into the bolt holes, then tighten until mounting plate and brackets are secure.
- Proceed with installing your bidet seat.