Prep your toilet
Remove your existing toilet seat, then turn off the shut off valve and drain the tank by flushing the toilet. Disconnect the water supply hose from the toilet tank fill valve.
Tip: You may need a wrench to disconnect the water supply hose. Use a container or towel to catch any excess water.
Install your T-valve
Connect your T-valve to the toilet tank fill valve, then reconnect the water supply hose to the bottom of the T-valve and connect one end of the bidet hose to the open side of the T-valve.
Tip: Use the provided thread tape to create a watertight seal on all thread connections, and hand-tighten everything to avoid stripping the connection threads.
Install your Element
Place your Element on the back of the toilet so the nozzles are centered in the bowl then line up the adjustable brackets with the bolt holes. Place your toilet seat on top of your Element and secure it using the original hardware.
Connect bidet hose to cool water inlet
Connect the open end of the bidet hose to the cool water inlet on your Element.
If you have an Element+ dual temperature bidet attachment, continue following the installation guide. Otherwise, skip to the last step.
If you have an Element+ dual temperature bidet attachment but you want to connect to cool water only, install the Hot Water Supply Cap on your warm water inlet, then skip to the last step.
Connect Element+ to warm water from your sink
Close the shut off valve to your sink’s warm water line and install the ⅜" T-valve to the hot water connection under your sink.
Connect hot water flex tubing to warm water inlet
Slide the pressure cap over the open end of your hot water flex tubing and insert the connector into the opening. Tighten the pressure cap. Reconnect the water supply hose to the top of the T-valve.
Tip: Make sure the warm water line is fully inserted onto both connectors for a watertight fit.
Connect hot water flex tubing to warm water inlet
Connect the open end of the hot water flex tubing to the warm water inlet on your Element+.
Final checks and steps
Check that connections are properly secured, turn on each shut off valve slowly while checking for leaks.
Please Note: Only use the provided installation hardware
Please contact us if you need alternate parts for your installation, we provide approved alternate hardware as needed. Substituting with unapproved or third-party parts will void your warranty, and Omigo will not be held liable for damages.