How do I turn the night light on/off?

Omigo & Omigo SL

1. Press and hold down the Power and Rear Cleansing auxiliary buttons (on the side of the seat) at the same time for 5 seconds until all the seat display lights start flashing.
2. Press the Rear Cleansing and Nozzle Cleansing buttons at the same time to Set or Cancel the night light. If the night light is flashing, it is ON. If the night light is not flashing, it is OFF.
3. The new setting will be saved in 10 seconds unless you press another button, or if you press the Stop button on the remote control.

Omigo GS

1. To deactivate the night light, press and hold “+” for four seconds.
2. To activate the night light, press and hold “+” for four seconds.
   Note: These functions cannot be performed while sitting on the seat.

What is Eco Mode?

Omigo and Omigo SL Eco Mode turns the seat temperature to the lowest setting after 10 minutes of non-use and will heat back to the previous temperature setting once you sit back down.

Omigo GS features two Eco Mode options: Standard (seat and water temp is set to 89.6 °F when not in use) and High-Efficiency (seat and water temp is turned off when not in use).

How much electricity does my bidet seat use?

Omigo uses a maximum of 1200W when heating and performing a wash cycle; the seat heater alone uses 60W

Omigo GS uses a maximum of 870W when heating and performing a wash cycle; the seat heater alone uses 55W.

How do I turn Eco Mode on/off?

By default, your bidet seat will arrive with Eco Mode off, enabling the seat to stay at your desired temperature setting at all times.

Omigo & Omigo SL

1. Press and hold down the Power and Rear Cleansing auxiliary buttons (on the side of the seat) at the same time for 5 seconds until all the seat display lights start flashing. Note: If the night light is turned on, it will also flash.
2. Press the Rear Cleansing button to Set or Cancel the Eco Mode. If the Eco Mode indicator light is flashing, it is ON. If the Eco Mode light is not flashing, it is OFF.
3. The new setting will be saved in 10 seconds unless you press another button, or if you press the Stop button on the remote control.

Omigo GS

1. Standard Eco Mode: Press the Eco Mode button until the yellow indicator light is on for Low energy-saving, and the seat and water temperature will be set to 89.6 °F. The bidet will then revert to the last seat and water temperature settings used. To deactivate, press the Eco Mode button until there are no indicator lights on.
2. High-Efficiency Eco Mode: Press the Eco Mode button until the green indicator light is on for High energy-saving, and the seat and water temperature will turn off when the bidet is not in use. Once a person sits on the bidet, the Swash will revert to the last seat and water temperature settings used. To deactivate, press the Eco Mode button until there are no indicator lights on.